Raider RD-ET03, User Manual, Page: 11 / 78

11
• cutter must not let it rain . The soil should not be wet or very damp .
• During operation, always watch out for the security position of the instrument .
• Use the device only in stepping pace.
• Be especially careful when you change direction when working on slopes .
• Be especially careful when you turn the router in another direction or shall draw to yourself.
• Switch off the engine and remove the cable when router is transferred from one to another
work site or transported to another location.
• Start the device with care and according to the manufacturer’s instructions . Watch for a
sufficient distance between the legs and cutting tools .
• Do not lift and carry the router with the engine running .
• Turn off the engine when moving away from the router .
• Allow the engine to cool before storing in a confined space cutter .
• Regularly check the bag for collecting grass for signs of wear and the ability to act.
• Before adjusting , cleaning and damage to unplug the power cord from the mains.
• connecting contacts must be made of rubber or soft PVC or other thermoplastic material , or
be coated with such material .
• Make sure the power cord is not wrapped around obstacles hindering free movement .
• Do not connect or disconnect the motor frequently within a short period of time.
• Consequently, the ripple of the voltage of the motor speed can be changed. In case of
insufficient supply powerful network some users within the same power circuit can be affected
when using electric mower . You can try to prevent this by switching to another circuit with less
powerful consumers .
• Unplug the power cord from the network :
- When you put the power mower - the occurrence of unusual vibrations Warning ! Read all
safety information and instructions . Failure to follow the safety precautions and instructions may
result in electric shock, fire and / or serious injury. Keep all safety instructions and the instructions
in the future.
2. Functional description and purpose.
The electric tiller is designed for soil treatment. It works after the soil is pre-ground late in the
fall or early spring. The surface layer of the soil is loosened with the help of the electric tiller. The
electric tiller is not designed to work on hard soil covered with dense grass, heavy rocky terrain
and etc.
3. PROPER USE
The machine is designed for digging soil (forexample garden beds). Be sure to observe the
restrictions in the safety instructions.
The machine is to be used only for its prescribed purpose. Any other use is deemed to be a case
of misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of
any kind caused as a result of this.
Please note that our equipment has not been designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the machine is used in commercial, trade or industrial
businesses or for equivalent purposes. The operating instructions as supplied by the manufacturer
must be kept and referred to in order to ensure that the machine is properly used and maintained.
The instructions contain valuable information on operating, maintenance and servicing conditions.
For safety reasons, the machine may not be used as a drive unit for other work tools or tool
sets of any kind.
4. BEFORE STARTING THE EQUIPMENT
ASSEMBLY
• Place the motor unit and the push bars on the ground in order
• Important. Do not forget to slide the cable strainrelief clamp over the bottom push bar.
• Slide the bottom push bar on to the push bar holder and secure the two components to each
other
• Now secure the top push bar to the bottom push bar
• Install the 2-hand safety switch as shown