Raider RD-EBC02, User Manual

Page: 16 / 88

16 www.raider.bg
6.2. Sharpening or replacement of the cutting edge.
Replace dull or damaged blades. Blade is removed by bolt unscrewed the main center of the knife
with a wrench 36. Before inserting a new blade or after you have banished the old one, make sure
the blade is positioned correctly and both pins are put into holes in the knife. Beware! One pin is
irregularly cylindrical shape and can only come into the corresponding hole of the knife. This ensures
the installation of the only knife in the correct position. Then tighten the bolt again and make sure that
no gaps and the knife is installed correctly. Use only suitable for hair cutters.
6.3. Always clean the main hair when I leave for longer storage. Especially in winter. Grease a knife
with oil to protect it from rust. To save space, you can disassemble the top of the hair on the bottom.
7. Faults and correct them.
The table below shows symptoms of failure and how you can help if your hair is no longer working
properly. If you can not find and fix the problem by following the instructions in the table, contact an
authorized service Ryder. Warning: before removal of damaged hair and stop it off from the mains.
Faults Removal Reasons
Mower does not
start to work
Power cable is not connected or
damaged
Check cable. If necessary, replace
it.
The engine is on,
but the knife does
not rotate.
Mower is in a tall grass. Upon initial release always put the
mower in the grass
It is possible that the mower is fuzzy
and the blade is blocked.
Disconnect the plug and check it.
Put on your protective gloves and
clean the knife and release
Engine is turned
off suddenly.
Plug is withdrawn
Check cable. Make sure it is well
enshrined in prispoblenieto (16)
and plug it again.
Unusual noise.
Bolt is loose or the blade connections
between fasteners.
Fasten the parts.
Strong vibrations.
Distorted and damaged knife. Immediately stop the mower and
replace the knife in a specialized
service.
Unequal mowing.
Engine work
hard and reduce
turnovers.
The grass is very high. Increase mowing height.
The knife is blunt. Replace or tipped knife. See 5.2.
It is possible that the mower is fuzzy
and blocked
Look underneath the mower
and clean it. Work always with
protective gloves.
The sword can be installed incorrectly. . Check. See 5.2
If necessary, repair your mower is best carried out only by qualified experts in workshops on
RAIDER, which used only original spare parts. Thus ensuring their safe operation.
8. Information on noise and vibration emitted.
The values are defined by Directive 2000/14/ES (1,60 m height and spacing 1,0 m). A level of noise
generated by the machine is usually the sound pressure level LpA = 82 dB. Guaranteed sound power