Raider RD-DH02, User Manual

Page: 11 / 92

11
is damaged, do not touch. Immediately disconnect the plug from the outlet.
Damaged power cables increase the risk of electric shock.
1.5.15. If the hammer is to be operated at low temperature or after long storage, allow the hammer
to operate for few minutes without load, for its internal elements get properly lubricated.
Do not use three jaw drill chuck when the hammer drill is set to hammer drilling or chiselling mode.
This chuck is designed only for regular drilling in wood or steel.
Failure of the considered instructions may lead to electric shock, fire and / or severe injuries.
2. Functional description and purpose of the demolition hammer
The machine is designed for drilling in concrete, brick, asphalt and stone.
Prior to operation
1. Power source Ensure that the power source
to be utilized conforms to the power requirements which specified on the name plate of the
hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power
receptacle while the power switch is in ON position, the demolition ha
mmer will start operation immediately, which can cause serious accident!
Operation
1. Press the switch after pressing the top of the accessory on the work surface. In some cases, it is
necessary to press the tip of the accessory to strike. This is not due to damage to the power tool. This
means that the anti-damage mechanism without load works.
2. Work with this hammer using moderate force. Efficiency will be better if moderate force is applied
to the handle against the work surface without depressing the machine.
Note:
Sometimes the power tool does not start a shock function, even if the motor continues to run because
the oil inside has thickened. If the power tool is used on site
high temperature, or used after a long time of idling to turn on the shock function must continue to
work more than 5 minutes to warm up
5. Support
The hammer is delivered without oil. The machine must be filled with oil before switching on for the
first time.
Observe the following sequence:
The hammer is placed in a horizontal position on the wide side.
Unscrew the plug with the wrench from the set or with a wrench or insert 23.
Pour 50ml of 15W40 oil.
Carefully clean the tail of the tool and grease it gently with grease.
Turn the lock to 180 ° and place the tool in a rotating motion in the
hole. Release the lock to lock the tool Check the lock by pulling the tool
(groove, cutter)
Removing
Whirligig the stop pin to 180° and remove the tool.