Radwin 5000 HPMP, User Manual

Page: 323 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 17 ‐ 3
Upgrading an Installed Sector
The list should include HBSs and HSUs able to accept the same upgrade. This is
unlikely to be a problem unless you are using equipment prior to the 3.3.00 release
of RADWIN 5000. Non ‐ upgradable items will result in an error message. Contact Cus ‐
tomer Service about upgrading them.
The center button allows you to add a single site:
Figure 17 ‐ 3: Adding a single site for upgrade
Enter the IP address of the site, the Read ‐ Write Community (Default: netman ) and
then click OK . The site will appear in the Software Upgrade list box.
Items from the list can be cleared by selecting them and then using the right button .
The right button in Figure 17 ‐ 3 , may be ruse to remove one or more selected sites.
3. Having created an update list, click Upgrade Package to chose the relevant files. The
default files are located in the SWU subdirectory in the RADWIN Manager
installation area. You may see one or more of the following SWU files:
For RADWIN 5000, always choose SWU_5k.swu.
4. To back up your existing system, check Backup device software check ‐ box. Then click
the button for a standard file dialog. The default location is the My
Documents directory on the managing computer or the last backup directory you
used.
Table 17 ‐ 1: SWU Files by product
File name Product
SWU_1k.swu WinLink 1000
SWU_2k.swu RADWIN 2000
SWU_5k.swu RADWIN 5000
SWU_gs.swu RADWIN GSU
Note
The backup here is the same as that on page 8 ‐ 1 , and serves the same
purpose. It provides a fallback if the upgrade proves problematic. Further
information about the backup utility is provided on page 17 ‐ 5 .