•
The weight unit is automatically changed to „pcs” and two screen
buttons on the right side appear:
Enter piece mass
Estimate piece mass
24.2. Setting a reference unit by entering known piece mass
Procedure:
•
Enter
mode
<
Counting Pieces> according to ch. 24.1
of this manual,
•
Press (enter piece mass), then an editing field is displayed
<Reference Unit> with the screen keyboard,
•
Enter a value and confirm it by pressing
, which causes starting
<
Counting Pieces> with automatic setting the reference unit.
Notice:
1. In case of entering a reference unit higher then the maximum weighing
range of the main scale the program will display a message box:
<Value too high>,
2. In case of entering the single piece mass lower than 0.1 d, the program
will display a message box: <Value to small>.
24.3. Setting a reference unit by weighing a sample
Procedure:
•
Enter
mode
<
Counting Pieces> according to ch. 24.1
of this manual,
•
If pieces are weighed in a container it needs to be put on the pan
and tarred,
•
Press (estimate piece mass), then the editing field is displayed
<Reference Quantity> together with the screen keyboard,
75
