RADVision SCOPIA 400, Platform Manual

Page: 10 / 39

2 SCOPIA 400 Platform Guide
About the Rear Transition Module
The chassis provides easy access for maintenance and board replacement.
Figure 1-1 SCOPIA 400 Chassis Front View
A
BOUT THE
R
EAR
T
RANSITION
M
ODULE
The rear panel of the SCOPIA 400 chassis contains four slots for the insertion of
Rear Transition Module (RTM) boards that connect to the chassis backplane.
The RTM provides a Circuit Switch Network connection.
V
IEWING
S
YSTEM
I
NDICATORS
You can view system-level monitoring information by monitoring the LED
indicators on the front of the SCOPIA 400 chassis. The LEDs are connected to
the chassis System Information Card (SIC).
Note
You can also monitor chassis functions remotely via the web user interface
of the MCU or Gateway installed in the top slot of the SCOPIA 400 chassis. If you
install a SCOPIA Media and Video Processor in the top slot of the SCOPIA 400
chassis, monitoring via the web is not available.
S
YSTEM
P
OWER
I
NDICATION
The POWER LED functions as follows:
Illuminates green to indicate that the power supply is operating
normally.
Illuminates red to indicate that one of the power supply units is
malfunctioning, or that one power feed is missing.
S
YSTEM
A
LARM
I
NDICATION
The ALARM LED functions as follows:
Illuminates green to indicate that the system is functioning normally.
Illuminates red to indicate that a system failure has been detected.
Check other LEDs to identify the type of failure.