|
37
Installation
CRONO-TH
Installation of “CRONO-TH” user terminal
• Be sure to comply with standards concerning
electric equipment to perform installation and
low power connection between the HP and the
CRONO-TH.
• Disconnect electrical power from the HP before
wiring the CRONO-TH.
• Use cable Modbus Belden 8762, or similar cable
to wire CRONO-TH
• The maximum length of the connection cable of
the CHRONO-TH is 100 m
Notes for installation of CRONO-TH
• Never install CRONO-TH above a stove or gas heater
or any other combustion device to avoid damaging
the electronic components and deforming the
outer casing.
• Do not install it in places exposed to steam coming
from stoves, pans or similar equipment, or exposed
to water or sprays from taps or the likes.
• Do not install in a position which is exposed to
direct sunlight.
• Install CRONO-TH in the same room as the
radiant system.
• Do not install in a room where industrial
chemical agents are used (ammonium, sulphur,
chlorine, ethylene compounds, acids, etc.).
How not to perform
installation
FORBIDDEN
Summary of Contents for CRONO-TH
Page 1: ...CRONO TH Installatiehandleiding Installation manual...
Page 23: ...CRONO TH MIRAI SMI Installation manual...
Page 43: ...43...