RADLEY 1281-914, Owner'S Manual

Page: 15 / 20

14
1281-914
ASSEMBLY AND OPERATING
INSTALLING ACCESSORIES
1. Turn the switch OFF and disconnect the tool
from the power source.
2. Depress the spindle lock button (1) and slowly
turn the collet nut (2) until the spindle lock
button locks the spindle (Fig. 4).
3. While holding the spindle lock button down,
turn the collet nut counter- clockwise until the
collet is loose inside the collet nut.
4. Insert the accessory (3) into collet.
NOTES:
a) Make sure the correct collet is used for the
accessory. If collet is too large, replace the collet
with the next smaller size. b) Insert accessory at
least 3/4" into the collet.
5. Press the spindle lock button and engage it
in the spindle. While holding the spindle lock
button down, hand-tighten the collet by turning
it clockwise.
NOTE:
Do not use pliers to tighten the collet nut.
Use the small wrench (4) supplied. Over tighten-
ing will cause damage to the tool.
6. Pull on the accessory to ensure it is securely
in place
WARNING: When using any new accessory for
the first time, particularly wire wheels, bristle
brushes and grinding stones, run the tool at
full speed for one minute to remove any loose
wires, bristles or stone particles. During this
initial run-up, always wear a face shield and
make sure you are NOT in line with the rotating
accessory to avoid injury caused by flying debris.
SELECTING PROPER SPEEDS
Different speeds are required depending upon
the type of operation being performed. The
chart to the right outlines those basic speeds:
Fig. 4
For safety reasons, the operator must read
the sections of this Owner’s Manual entitled
"GENERAL SAFETY WARNINGS", "POWER
TOOL SAFETY", "SPECIFIC SAFETY
RULES", "EXTENSION CORD SAFETY" and
"SYMBOLS" before using this rotary tool.
Verify the following every time the rotary
tool is used:
1.
Safety glasses, safety goggles, or face
shield are being worn.
2.
Accessory is in good condition and not
damaged in any way.
3.
Workpiece is properly secured.
Failure to observe these safety rules will
significantly increase the risk of injury.
WARNING !
OPERATION SPEED
Cutting metal 5–MAX
Sanding wood 5–MAX
Cutting hard metal 5–MAX
Engraving metal 4–5
De-burring 4–5
Drilling holes 4–5
Removing rust 3–4
Sharpening 3–4
Polishing 1–2