13
4 Amp Jigsaw - Owner's Manual
SETTING THE BEVEL CUTTING ANGLE – cont’d
4. Slide the base forward to engage the
bevel angle slot (6) with the indexing
pin (7) (Fig. 5)
NOTES:
a) Use a protractor to check the bevel
angle between the blade and the base.
b) To set the bevel angle at intermediate
angles, do not slide the base forward.
5. Once the desired bevel angle is
obtained, lock the base by tightening
base pivot screws.
6. Make a test cut in a scrap piece of
material and measure the bevel angle.
Adjust the bevel angle if necessary.
SETTING THE ORBITAL CUTTING ANGLE
The variable orbital cutting action allows you
to select one of four different blade angles.
To set the orbital cutting angle, rotate the
orbital cutting lever forward or backward
to the desired setting number (1) (Fig. 6).
NOTE:
The orbital setting button will "click" at
each of the four positions. Slide the orbital
button slightly forward or backward until
it locks into place.
ASSEMBLY AND OPERATING
(continued)
Fig. 4
Fig. 5
Fig. 6