PROMENTUM™
COMPUTE PROCESSING MODULE
INSTALLATION GUIDE
ATCA-4300
ATCA-4310
This document describes how to install and set up the Promentum
ATCA-4300 or ATCA-4310 compute processing module (CPM).
ESD procedures
W
ARNING
!
Obey the electrostatic discharge (ESD) procedures
described at
www.radisys.com/esd
when you install the
product. Electrostatic discharge can cause permanent damage
to static-sensitive components in this product.
Important ESD procedures include:
Keep the product in its ESD shielding bag until a step tells
you to remove it.
Put on a grounded wrist strap before you move near or
touch the product.
Install the product only in a grounded work area.
Before you begin
Check your parts and accessories.
Included in the package
An ATCA-4300 or ATCA-4310 CPM.
Optional components
A rear transition module (RTM).
1 or 2 advanced mezzanine cards (AMCs).
Not included in the package
An AdvancedTCA
®
shelf, such as the ATCA-6000 or
ATCA-6006.
An installer for an operating system (OS), such as Red Hat
®
.
The Promentum software distribution (
www
.
radisys.com
).
A USB CD-ROM drive and CD or another USB storage device
from which to retrieve the OS for the initial installation.
A USB cable.
A console serial cable (RJ-45 to DE9-S, RadiSys order code
ATCA-SERIAL-CBL). The same cable is included in shipments
of the ATCA-2210 switch and control module.
Note:
This installation guide instructs you to load an OS from a
CD-ROM drive when you initially install the CPM. If an OS is
already installed (for example, on a hard drive AMC), you can
ignore many of the steps.
007-02236-0002 • May 2008
Copyright © 2007–2008 by RadiSys Corporation. All rights reserved.
RadiSys is a registered trademark and Promentum is a trademark of RadiSys Corporation.
All other trademarks, registered trademarks, service marks, and trade names are the property of their respective owners.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
