RadiSys P3000BX2 Series, Service Manual

Page: 55 / 64

Technical Data
Service Manual EPC-2322 SBC (P3000(D)BX2 Series) 47
Single
Processor To properly operate a single Pentium III processor in the P3000BX2:
• Install the processor in the primary slot
• Install a Slot 1 terminator card in the secondary slot
Note : The terminator card must be rated for 100 MHz host bus (front-side bus)
operations.
Terminator
The procedure for installing a Slot 1 terminator card ( Figure 17 on page 48 ) is outlined in
the following table:
Failure to properly install a single processor with adequate termination can
cause damage to the equipment and could void the warranty.
Step Action
1 Insert the terminator card into the retention bases.
Note: The terminator card and the processor connector are both keyed to
prevent improper installation.
2 Lower the terminator card to the processor connector. Carefully push the
terminator card into the connector.
3 Insert the terminator card fastener into the retention bases.
Note: The fastener is slotted so that the top of the terminator card will protrude
through the fastener.
4 Lower the terminator card fastener to the terminator card. Carefully push the
fastener into the retention bases until the fastener engages the bases.
Note: The fastener has a clasp on each end. These clasps will engage slots in
the rear of each retention base.
StockCheck.com