RadiSys EPS-6315, Hardware Reference Manual, Page: 37 / 123

Chapter 4: BIOS configuration
27
Primary Master/Slave sub-menus
There are two IDE adapter sub-menus for the primary hard disk controllers: a
master and slave drive menu.
Access this screen to:
• See or reconfigure the detailed characteristics of the primary hard disk (select
the IDE Adapter 0 Master item from the Main BIOS Setup).
• Set up new disks and allow the Setup program to determine the proper settings
based on information on the disk. Note that the Setup program can detect these
settings only on drives that comply with ANSI specifications.
• Set up existing (formatted) disks. Note that you must use the same parameters
used when the disk originally was formatted. You must select an option for the
Type field, then enter the specific cylinder, head, and sector information listed
on the label attached to the drive at the factory.
Figure 4-2. Primary Master/Slave sub-menus
Main
F1 Help
↑↓
Select Item –/+ Change Values F9 Setup Defaults
ESC Exit
←→
Select Menu Enter Select Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Main
<Tab>, <Shift-Tab>, or <Enter>
selects field.
Item Specific Help
System Time: [16:17:18]
Type: [Auto]
Cylinders: [490]
Heads: [ 8]
Sectors: [ 32]
Maximum Capacity: 64MB
Multi-Sector Transfers: [Disabled]
LBA Mode Control:
[Disabled]
Transfer Mode: [Fast PIO1]
Ultra DMA Mode [Disabled]
Primary Master [Primary Master ]