Page 6
Copyright © 1997 Radionics, Inc.
D7024 Reference Guide
2.0 Enclosure Installation
The D7024 control/communicator and the enclosure are
shipped together. The control, however, still needs to be
installed into the enclosre. Hardware for mounting the
enclosure to a wall, and the control to the enclosure is
located in the hardware pack.
2.1 Install the Enclosure
• Use the enclosure as a template and mark the top
mounting holes on the mounting surface.
• Pre-start the mounting screws for these two holes.
Slide the enclosure onto these mounting screws so
that the screws move up into the thinner section of
the holes. Tighten the screws.
• Screw in the remaining two screws in either set of
bottom mounting holes.
• Knock out the desired wire entrances on the enclo-
sure.
2.2 Install the Control/Communicator
CAUTION: The control is static sensitive. Make sure
you touch ground before handling the
control. This will discharge any static
electricity in your body. Example: Run the
ground wire to the enclosure before
handling the control. Then keep holding the
ground wire while installing the control.
• Insert the two support posts into the control retainer
holes as shown in the diagram below.
• Press the 1/8" nylon standoffs into the control
retainer holes as shown. This provides support
behind the control.
• Slide the top of the control into the retainer tabs (the
slots under the top of the frame).
• Once in the retainer tabs, the control will rest on the
two support posts.
• Secure the bottom of the control by screwing the 2
bottom corners through the support posts and
through to the control retainer holes.
CAUTION: Once the control is installed, be sure to
connect the supplied ground wire between
the door and the enclosure using the
supplied nuts.