Matching
Box
Coaxial
connector
Hole
A
Male
Female
White
dots
40m
30m
20m
17m
15m
12m
10m
6m
Figure 7
( ) Identify the pair of 3-wire antenna elements (6, 10 and 12m).
( ) Connect to the corresponding female connector on the matching
box. Note that one of the connectors has a white dot that must
match the marking on the box connector (figure 7)
and secure with a nylon nut. Do not tighten too much to prevent
( ) In all other large holes, attach an nylon fastening element using
damage to the fiberglass.
of the tubes (photo 2). Do not tighten too much.
( ) Insert a nylon hex bolt in each of the two points "A" (figure 9)
a nylon nut to secure. Place all the cable clamps towards the end
each band. With the weight of the wires, it is natural for the tu-
of the plate. Simply screw the mast firmly.
band fastening element (the larger antenna) using a nylon clamp
( ) Release all five ropes. The shorter rope must be attached to the
( ) Connect both sides, respecting the identification.
( ) Pass all the wires inside each of the nylon clamps, according to
( ) Identify the 5-wire antenna pair (15, 17, 20, 30 and 40m)
.
that must be attached to the each fastening element (photo 3).
bes to bend.
( ) Connect the male connector that has the white dot to the female
ning connector.
matching box tube (point "D" in figure 9). Use a nylon clamp
( ) Install the central mast with support ropes on the central thread
( ) The other ropes must be attached to each of the four 40 meter
connector that has the white dot and the other one to the remai-
and nylon nut.
10
11
Photo 2 - How to fix the fastening elements to tubes
Photo 3 - Cable clamp assembly detail
