RD400PDL-2/PXL-2 User Guide
FaultFinding
Press the A-V-O key to display current (mA).
Press the Up or Down keys to set the required
output current level (typically 20 mA). In situations
where there is a high degree of interference
selecting a higher current may be desirable.
If it is not possible to obtain sufficient current,
check connections to cable/sheath and Ground
Stake. If necessary change position of the ground
stake or pour water around the stake in dry or
sandy conditions.
Cable Fault Finding with the A-Frame
CD Signal Method
Carry out the procedure in the 'Transmitter Setup'
section.
Using the Transmitter Mode key, move the pointer
so it points to the CD icon, the pointer will flash.
Press the Select key to set the Transmitter to the
CD mode, the pointer will stop flashing.
Note: Lf will also be selected as the CD signal
utilizes this frequency.
Connect the A-Frame to the Accessory Socket of
Receiver.
Switch the Receiver On and select CD using the 'f'
key.
On/Off
A-V-O
Up
Line
Select
Mode
Down
FF Normal
FF Boost
Connect 24V
Connect 50V
Lf
8k
33k
65k
User Hz
Multi
mA
Radiodetection Corp.
PO Box 623
Ridgewood, NJ07451, USA
Radiodetection
Radiodetection Ltd.
Western Drive
Bristol BS14 0AZ, UK
01/MH1054L1ENG/3
Connect
Fuse
12V
Adaptor
Serial No.
On/Off
A-V-O
Up
Line
Select
Mode
Down
FF Normal
FF Boost
Connect 24V
Connect 50V
Lf
8k
33k
65k
User Hz
Multi
mA
Radiodetection Corp.
PO Box 623
Ridgewood, NJ07451, USA
Radiodetection
Radiodetection Ltd.
Western Drive
Bristol BS14 0AZ, UK
01/MH1054L1ENG/3
Connect
Fuse
12V
Adaptor
Serial No.
8
33 65
Lf
a
b
