21
22
Menu No.
Menu
Selection
Description & Default settings
Set back to the factory default settings.
FACTORY
：
Reset back to the factory settings of menu
INITIALIZE
：
Reset back to the factory settings of menu and channel.
FACTORY
INITIALIZE
30
RESTORE
01: T-CDC
The setting is for turning off or activating CTCSS/DCS code in transmit frequency.
Press 1 on the mic to select the type of CTCSS/DCS: 67Hz-254.1Hz, 000N-777I.
02: R-CDC
The setting is for turning off or activating CTCSS/DCS code in receive frequency.
Press 1 on the mic to select the type of CTCSS/DCS: 67Hz-254.1Hz, 000N-777I.
Press
DN
or UP
on the mic to select CTCSS/DCS code.
03: RT-CDC
CTCSS/DCS codes are privacy codes, Only when the code of the transmit frequency and receive frequency is
matching you can transmit or receive the signal on the same channel.
The setting is for turning off or activating same CTCSS/DCS codes in transmit and receive frequencies.
04: TONEDEC (Optional Signaling)
It is an Optional Signaling, this feature is similar to CTCSS/DCS. When the receiver adds optional signaling, the
caller shall transmit matching signaling. DTMF and 5Tone signaling can be applied for other advanced features such
as ANI, PTT ID, group call, select call, remotely stun, remotely kill waken etc..
*Note:
Only available in Channel Mode
05: SINGAL
This transceiver has 5 squelch modes available. Squelch function is used for increase the level of filtering unwanted
signal, and free from disturb.
SQ: You can hear the calling once receives matching carrier.
CTSS/DCS: You can hear the calling when receives matching carrier and CTCSS/DCS code.
TONE: You can hear the calling when receives matching coptional signaling.
CT*TO: You can hear the calling when receives matching c
CTCSS/DCS + optional signaling.
CT/TO: You can hear the calling when receives any matching carrier or CTCSS/DCS or optional signaling.
06: STEP
You can select the desired frequency step.
The selectable steps are the following: 2.5/5.0/6.25/10.0/12.5/20.0/25.0/30.0/50.0 KHz
*Note:
Only available in Frequency Mode
07: W/N
This function is used to set the working bandwidth of the radio.
You can choose between wide or narrow bandwidth.
Wide: 25KHz
，
Narrow: 12.5KHz
11: RPLOCK
CTCSSS /DCS: Channel Busy and lock. When the radio receives a matched carrier, transmission is prohibited.
OFF: Always allow transmitting no matter what status of receiving.
REPEATER: Signaling Busy and lock. When the radio receives a matching carrier, but CTCSS/DCS does not match,
