20-428 Owner’s Manual
Page 16 of 50
channel transmissions, trunk IDs, or banks.
assigning a text tag to a channel
1. Press MAN, enter the channel number where you want to enter the text, then press MAN again.
M and the bank and channel number appear at the upper left corner of the display (for example:
M100).
2. Press PROG. M changes to P.
3. Press TEXT. The cursor appears at the third line.
4. Enter the text using the numeral keys (see “Text Input Chart”).
Note: If you make a mistake, press /¥ or ¥/ to move to the character you want to change.
For example, to identify amateur (ham) radio transmissions in the 6 meter range, input “HAM 6m”
as follows:
•
“H” is the second letter associated with 4 on the keypad. Press 4 then 2.
•
“A” is the first letter associated with 2 on the keypad. Press 2 then 1.
•
“M” is the first letter associated with 6 on the keypad. Press 6 then 1.
•
A space is entered by pressing
•
/DELAY.
•
“6” is the sixth number associated with 1 on the keypad. Press 1 then 6.
•
“m” is the first letter associated with 6 on the keypad. Press 6 and FUNC (for the lower case set),
then press 1.
5. Press ENT to input the text.
assigning a text tag to a group ID
1. Press PROG.
2. Press TRUNK.
3. Press FUNC then /¥ or ¥/ to select the desired bank.
4. Press TRUNK to select the desired sub-bank.
5. Press or hold down /¥ or ¥/ to select the desired group ID.
6. Press TEXT then enter the tag using the keypad. (See “Text Input Chart”).
