DX-375 (200-0212)
Operation
Follow these steps to listen to the receiver.
WARNING: To prevent possible ear injury and hearing loss, set VOLUME to
MIN before you turn on the receiver. After you turn on the
receiver, set VOLUME to a comfortable listening level.
1. Press POWER to turn on the receiver.
2. Press BAND until the desired band (FM, AM, or SW) appears on the
display. (See "Selecting the Band.")
3. Press MANUAL/AUTO or PRESET/DIRECT ACCESS to tune to the desired
station. (See "Tuning to a Radio Station.")
4. Adjust your receiver's antenna for the best reception. (See "Using
the Antenna.").
5. Adjust VOLUME and TONE as desired.
6. Press POWER to turn off the receiver.
SELECTING THE BAND
You can select the Frequency Modulation (FM), Amplitude Modulation (AM),
or the 12-band Shortwave (SW) band of operation.
Press BAND until the desired band (FM, AM, or SW) appears on the display.
If you select FM, FM, MHz and STEREO (when you tune to a stereo
broadcast) appear on the display.
NOTE: Your receiver has only one speaker. To listen to a stereo
broadcast, use stereo headphones (not supplied).
If you select AM, AM and kHz appear on the display.
If you select SW, press SW SELECT to access the international radio
frequency bands. As you press SW SELECT, SW BROADCAST BAND and the
lower end of each broadcast band appear on the display.
NOTE: If you press and hold SW SELECT for more than 2 seconds, the
receiver automatically scans all broadcast bands in sequence and
stops on the same band where you were when you pressed SW SELECT.
To stop the scanning at a desired band, press SW SELECT again or press <DOWN
or UP>.
TUNING TO A RADIO STATION
You can tune to a desired broadcast station using the manual, search,
