11
Beyond the Basics
initializing your Motion Detector
Remove the cover on the front of the Motion
Detector and install two AA alkaline batteries in
the compartment, matching the polarity (+ and -)
marked inside. Replace the cover.
Press and hold the
TEST
button on the back of
your Motion Detector for three to four seconds, and
then release it. This initializes your Motion Detector
and picks a random code that is used when it is
registered with your Security Console. Place the unit
face down, so it won’t detect any motion during the
registering process.
registering your Motion Detector
with the Security Console
Press either of the Menu
/
buttons. The display shows “ENTER
PIN” in the top line. When you enter your PIN, * displays for each
number entered.
Press
ok
when you see “INSTALL” on the display.
Press the
TEST
button on the back of your Motion Detector (or turn
the unit over so that it sees motion). Your Security Console will
acknowledge it has been registered by displaying “ZONE (number)
SET."
Repeat these steps for other Motion Detectors you want to register.
Your display shows incremental Zone numbers as you install each
Motion Detector, such as Zone 4 SET, Zone 5 SET, and so on.
If desired, you can specify the zone for which you want your Motion
Detector to be installed. Simply press the number of the zone you want
on your Security Console’s keypad before you press the
TEST
button
on the back of your Motion Detector.
Repeatedly press
clear
to back out of the menu. To confirm your
selection, press
1
for YES, or
2
for NO. Pressing 1 takes you back to
the “HOME CONTROL” screen. Pressing 2 takes you up one menu
level.
TEST
CLEAR
OK
49-1000 UG.indd 11
7/27/2004 6:49:36 PM
