In
s
ta
lla
ti
o
n
5
To mount the phone directly on a wall, you need two screws
(not supplied) with heads that fit into the keyhole slots on
the back of the base. Drill two holes 3
15
/
16
inches (100 mm)
apart. Then thread a screw into each hole, letting the heads
extend about
1
/
8
inch (3 mm) from the wall.
1. Plug one end of the supplied modular cord (long for a
desktop or direct wall mounting, short for a wall plate)
into the
TEL
LINE
jack on the bottom of the base.
2. Insert the supplied AC adapter’s barrel plug into the
DC
IN 9V
jack on the bottom of the base and route the
adapter’s cord through the strain relief slot on the base.
3. Route the adapter and modular cords
through the molded routing channels
on the back of the base as
shown here.
4. For a wall plate, plug the other
end of the short modular cord into
the wall plate jack.
5. For a wall plate or direct wall
mounting, align the base’s keyhole slots with the wall
plate studs or mounting screws and slide the base
down to secure it.
6. For a desktop or direct wall mounting, plug the other
end of the modular cord into a modular phone line jack.
7. Plug the adapter into a standard AC outlet.
%
100'%6+0)
"
#0&
"
%
*#4)+0)
"
6*'
"
$
#66'4;
"
2
#%-
The phone comes with a rechargeable nickel-cadmium
battery pack in the handset, but not connected. Before using
your phone, you must connect the battery pack, then charge
it for about 15–20 hours.
#
1. Press down and slide off the battery compartment
cover in the direction of the arrow to remove it.
2. Lift the battery pack out of the compartment.
3. Plug the battery pack’s connector into the socket in the
compartment (the connector fits only one way), then
place the battery pack in the compartment.
4. Replace the cover.
To charge the battery pack, place the handset on the base.
The CHARGE/IN USE indicator on the base lights.
Recharge the battery pack when the handset beeps and
TALK/BATT flashes.
R
#
"
+/2146#06
"
#
The EPA certified
RBRC
®
Battery
Recycling Seal on
the nickel-cadmium
(Ni-Cd) battery
indicates RadioShack is voluntarily
participating in an industry
program to collect and recycle
these batteries at the end of their
useful life, when taken out of
service in the United States or
Canada. The RBRC program
provides a convenient alternative
to placing used Ni-Cd batteries
into the trash or the municipal
waste stream, which may be illegal
in your area. Please call 1-800-
THE-SHACK (1-800-843-7422) for
information on Ni-Cd battery
recycling and disposal bans/
restrictions in your area.
RadioShack’s involvement in this
program is part of the company’s
commitment to preserving our
environment and
conserving our
natural resources.
R
"
9#40+0)
ý
R
"
Dispose of the old battery pack
promptly and properly. Do not
burn or bury it. See “Battery Safety
Instructions” on Page 3 for
additional information on proper
battery handling.
AC Adapter Cord
Modular
Cord
43-3533.fm Page 5 Friday, June 28, 2002 2:36 PM
