MOUNTING THE PHONE
Direct Wall Mounting
Desk Mounting
Plug long cord into the phone’s jack on the back of the
phone then plug the other end into a phone line jack.
3
/
16
31
/
4
ÐÐ
USING THE PHONE
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C.
2000 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
Hold down
MUTE
to keep
the other party from hearing
you. To resume the conver-
sation, release
MUTE
.
Press
FLASH
in place of
the switchhook for spe-
cial services such as Call
Waiting.
Note: If you do not sub-
scribe to any special ser-
vices, pressing
FLASH
might disconnect the call.
Press
PAUSE
to enter a
pause for systems that
require an access code
(9, for example) before
you can dial an outside
number.
Set
VOLUME HI/MED/LO
to adjust the
volume you hear through the handset.
Set to
TONE
or
PULSE
to match the type
of service you have. If you have pulse
(rotary) service, you can switch to
TONE
during a call to use tone services.
Set the ringer Hi-Low switch to the left for a high ringer volume. Set the
switch to the right for a low ringer volume.
Plug the handset cord into the jacks
on the base and handset.
If you have pulse service,
press
TONE
to dial numbers
with tone signals. The phone
returns to pulse dialing when
you hang up.
Press
REDIAL
to dial
the last number dialed
up to 31 tone and 32 pulse
numbers.
Plug the handset cord into the
jacks on the base and handset.
Convienent keyhole slots are located on the
base of the phone to provide easy wall
mounting. Adjust the handset holder by slid-
ing the clip up. Then rotate it and slide it
back into the slot.
To mount the phone directly on the wall, connect the
supplied long cord to the phone’s line jack and route it
through the strain relief on the bottom of the base. Drill
two holes 3
1
/
4
inches (83 mm) apart. Then thread a
screw (not supplied) into each hole, letting the heads
extend
3/16
inch (5 mm) from the wall. Fit keyhole slots
over screws, slide the phone down to secure it into
place. Plug the cord into the wall jack.
Mounting on a Wall
Mounting on a Desk
