5
CONNECTING POWER
Before connecting power, remove all
batteries from the charger. Insert the
supplied adapter’s barrel plug into the
DC 12V 500 mA
jack on the back of the
charger. Then plug the other end of the
adapter into a standard AC outlet.
00
appears and
flashes on the display.
OPENING THE COVER
To open the cover, press the tab below
the cover and lift up the cover.
CHECKING 1.2V
BATTERIES
You can use this charger to check the
charge in a 1.2V Ni-Cd/Ni-MH battery.
(You cannot use this function to check
the voltage of a 9V battery.)
1. With the charger connected to AC
power, place a single battery into
any chamber. Do not close the
cover yet (this starts the charging
process).
2. Press
ANALYZE
.
The charger dis-
plays the estimated
charge level, with
the amount-of-
charge symbol and
the numeric charac-
ters showing the
voltage.
Notes:
• The amount-of-charge shown is
based on the normal discharging
curve of a fully charged battery. It
might be inaccurate if the battery
being checked was not fully
charged before it was last used.
23-410.fm Page 5 Friday, August 6, 1999 2:54 PM
