10
Scanner Setup
2. The hour digits flash. Press
T
or
S
or press the number keys to enter
the hour. Then press
ENT/PROGRAM
to set.
3. The minutes digits flash. Press
T
or
S
or press the number keys to enter
the minutes. Press
ENT/PROGRAM
to set.
Note: When setting the clock minutes, the seconds digits are reset
to 00 to enable accurate time adjustment.
4.
AM/PM
flashes. Press
T
or
S
to select
AM
or
PM
. Press
ENT/PROGRAM
to set.
5. To save your selection, slide the
Clock
Switch
to
Clock
.
6.
To set the alarm, slide the
Clock Switch
to
Alarm Set
and repeat steps 2-5.
Alarm Function
•
Slide the
Alarm Switch
to
Tone
, if you want the alarm to sound a tone
at the set time.
•
Slide the
Alarm Switch
to
Radio
if you want the alarm to sound with
the channel that was previously selected in Scan Mode. The radio
alarm will only sound in Standby Mode.
•
To silence the alarm, slide the
Alarm Switch
to
Off
. If you do not turn
off the alarm, it will sound for 20 minutes then reset to alert you again
the following day.
Programming Frequencies into Channels
Before the scanner can begin to scan, you must program a frequency into at
least one channel.
To locate and store specific frequencies into channels for later use:
1. From Scan Mode, press
SCAN/MAN
to stop scanning.
2. Press
ENT/PROGRAM
to put the scanner in programming mode.
PGM
appears.
3. Use the number keys to enter both the channel storage bank and the
channel number you want to assign to a frequency.
4. Press
SCAN/MAN
.
