Radio Shack 12-262, User Manual, Page: 10 / 26

10
1. Press MENU/SELECT and press

or

to select
BACKLIGHT?
setting. Then, press MENU/SELECT.
2. Select
ON
,
OFF
, or
AUTO
. If you select
AUTO
, the backlight turns on
for 10 seconds when a key is pressed, an alert is received, or the AC
adapter is plugged in.
3. Press MENU/SELECT again and press

to exit.
backlight setting
1. Unplug the AC adapter and remove the backup batteries.
2. While holding down
WEATHER/SNOOZE , plug the Hazard Alert
Radio’s AC adapter into an outlet or install batteries.
USER SETUP
displays and the radio beeps. Then release WEATHER/SNOOZE .
3. Press MENU/SELECT to clear the memory and restore the factory
settings.
DEFAULT
displays. Wait 5 to 10 seconds until
USER SETUP
displays.
4. Unplug then plug in the AC adapter and install batteries.
SET
LANGUAGE
displays. You must reinitialize the radio (see pages 2-3).
resetting your hazard alert radio
1. Press MENU/SELECT and press

or

until
SIG REMINDER
displays. Press MENU/SELECT to enable or disable it. (
%
displays
when enabled and Í displays when disabled.)
2. Press  to exit.
• Press any button to mute signal loss reminder alert. If a
signal is detected for less than 10 minutes and lost again, no
signal loss reminder will sound.
• If the signal is lost ,
SIGNAL LOSS
appears and
Ê
flashes
on the display. WARNING and ADVISORY alert LEDs flash
alternatively, and WATCH LED lights.
signal loss reminder setting
NOTE