Servo arm
“Z” bend
4-Aileron Linkage
TOP-VIEW
Clevis
1- Install one clevis onto each of the aileron torque rod horn. With the aileron
and aileron servo in the neutral position, mark the position where it each of
the linkages will attach to the servo arm.
2- Insert the aileron linkages into the servo arm accordingly.
Ensure that the servo is centered. If necessary ,
adjust the metal clevies so the ailerons are also in
the neutral position.
Aileron torque rod
horn
5- Main wing/installing the main gear
3x12 mm screw
4mm collar
Cut away only the covering.
BOTTOM-VIEW
Nylon strap
Main gear
1- Locate the main landing gear struts and
place them into the landing gear slot as
show. Make sure that the ends of the
struts are inserted into the holes in the
landing gear channel.
2- Position the four nylon straps across
the landing gear struts. Using the eight
3x12mm screws located in the hardware
bag, fasten the landing gear to the bottom
of the wing as show.
3- Slide one wheel onto each of the landing
gear axles and secure them with the
supplied wheel collars.
Hinge Line/Control horn
Alignment
A B
2x12mm screw
6- Horizontal stabilizer
2mm
A
A’
A=A’
B
B’
B=B’
1- Trial pit the horizontal stabilizer in place on the fuselage
2- Use a pencil to trace around the bottom of the stabilizer where it
meets the fuselage.
3- Remove the horizontal stabilizer from the fuselage, cut away the
covering inside the lines which were marked above.
4- Install the horizontal stabilizer onto the fuselage, secure it in place
using epoxy or CA glue.
Clevis
.........2
.........4
Nylon strap
3x10mm screw
.........8
4mm collar
.........4
Cut away only
the covering.
Control horn
...........2
! Make sure to glue securely, If not properly
glued, a failure in flight may occur.
2x12mm screw
...........4
FUSELAGE TOP-VIEW
(30 min.)
* WARNING: When removing any covering from the airframe, please ensure that you secure the cut edge with CA or
similar cement. This will ensure the covering remain tight.
* WARNING: When removing any covering from
the airframe, please ensure that you secure the
cut edge with CA or similar cement. This will ensure
the covering remain tight.
