10
RETURN FITTING ASSSEMBLY
The return fitting kit includes 3 parts: inlet fitting, inlet plate and back nut.
Install the inlet fitting into the pre-cut hole, slide the inlet plate over
the exposed threads and then thread the back nut onto the fitting.
DO NOT OVERTIGHTEN.
Back Nut
Inlet Fitting
Inlet Plate
Pool
Interior
Pool
Exterior
For additional return fittings, drill 3” ( with 3” hole saw) hole
12” down from top of panel. Edges will be sharp but not in
contact with liner or hands once wall fitting has been installed.
Install return wall fitting per directions, firmly.
Do not over
tighten.
Note:
For the Radiant LED light, drill hole 14” down from top
of panel. Installation is identical to return fitting.
The return faceplates are attached after the liner is installed.
Dished bottom option
Bring the required amount of clean and washed masonry sand into
the interior of pool area. Refer to the chart for the required amount.
Once the sand has been placed inside the pool, install the remaining
wall panel.
SAND REQUIREMENTS
(1 yard masonry sand = appx 1.5 tons)
16’ 1.8
18’
2
21’
3
24’
3.5
27’
4.5
30’
5.5
33’
6.5
Sand Amt
(cubic yds)
Pool
Size
PREPARING POOL COVE
Pool Cove
Pool Interior
N.
Using the masonry sand, build a pool cove 4” to 6” high inside the
wall along the entire circumference of the pool.
(fig. N)
This will prevent
the liner from creeping under the wall.
This step is not optional and
must be done.
Spread the remaining sand equally across the bottom
of the pool. This will give you a 2” sand base.
After the cove and base are in place, dampen, rake
and tamp the entire pool area. Make sure that no
sand is allowed to remain on the wall above the cove.
This could cause pinholes in your liner.
Once bottom and pool cove are set, install final panel.
Sand Base
