For warranty information please visit
radiantlighting.com.au/warranty
6.
Wiring diagrams & connection options:
Even though each application of strip lights is different from the previous, it can be simplified to
several installation methods.
a) Parallel connection:
All strips are being wired back to single power adapter. This is ideal for scenarios when an installation has many short cuts of LED
tape (shelving). Can also be used in situations with centrally located power supplies.
b) Serial Connection:
Individual cuts of strips are being connected to a single power supply in series, linked with wires inbetween. Typically, this method
is used when continued length of strip has to be split into several lengths in order to run wires through obstacles. Maximum continued run in series
cannot exceed 5m (<1m tolerance)
c) Central connection:
In the event that continued lengths of strip are required (no room for drivers), it is recommended to split them into 2x5m sections and
supply power from a central point. Each strip will be taking an equal amount of current, preserving the lifespan of the strips and giving even light distribution.
Please note:
Overheating can be caused & damage the first 1-2m of LEDs and FPC (flexible printed circuit-board) by connecting more than 5m of continuous
length in series and without power connected on both ends. This is due to the high current flowing gthrough the length of the circuit.
Incase of any queries, please do not hesitate to contact our technical support team:
Email: [email protected] Ph:1300 438 609
25
m MAX
for 5W | 20m MAX for 10W | 15m MAX
FUSION
LED PCB STRIP
25
m MAX
for 5W | 20m MAX for 10W | 15m MAX
25
m MAX
for 5W | 20m MAX for 10W | 15m MAX
25
m MAX
for 5W | 20m MAX for 10W | 15m MAX
25
m MAX
for 5W | 20m MAX for 10W | 15m MAX
25
m MAX
for 5W | 20m MAX for 10W | 15m MAX
