MAINTENANCE
5
OPERATING INSTRUCTIONS:
1. Set the tray containing goods or materials on the work table.
2. Pull the wrap film from the gap of work table rollers and cover the tray or material with film.
3. Draw down the wrapped tray to the heat plate. At this point, the heat cutter will cut the film by
heat automatically.
4. Put down the tray on the plate and press the tray lightly several times.
5. Check the wrapped tray.
GENERAL INSTRUCTIONS:
1. Fuse – This machine uses a 2A fuse on the name plate. 2A simply means 2 Amp fuse.
2. Work Table – The goods for wrapping must be set on the work table.
ALWAYS USE THE TRAY WHEN YOU WRAP GOODS.
DO NOT WRAP ANY TRAY THAT CONTAINS WATER.
3. Tension Bolt – This tension bolt is to have elasticity in pulling of the film.
4. Control Board – This board controls the voltage that is given by volume level.
DO NOT USE TRAY IF IT CONTAINS WATER OR OIL
DO NOT TOUCH THE CUTTER AND COVER BY HAND
USE 2A FUSE ONLY FOR THIS MACHINE !
REPLACING THE HEAT CUTTER:
1. Unscrew the cutter cover standing screw and take the cover away from the cutter.
2. Release the cutter wire holding screw.
3. Pull the cutter wire from the front panel wire.
4. Release the new cutter and tighten the screws.
