6
OUTPUT PANEL FEATURE SET
True to the Music
X•AMP User Guide
Radial Engineering
6. Power-on LED indicator
The power-on LED will immediately illuminate when the 15VDC
supply is connected. There is no power switch on the X-Amp
and leaving the X-Amp on will not harm the unit.
7. Output level control
The output LEVEL control sets the level going from the two 1/4”
output connectors to the guitar amplifiers. This recessed
potentiometer is adjusted using a guitar pick or flat-head
screwdriver.
8. Input overload LED indicator
To ensure the signal from the mixer or recorder does not overload
the X-Amp, a clip indicator is positioned on the front panel for
clear viewing. If this LED illuminates, turn down the mixer!
9. Out-1: Direct ¼” output to guitar amp 1
This is a transformerless, direct-coupled output and is used to
connect to the primary guitar amplifier and provides the primary
ground path for the X-Amp. This output is always used and
should be connected to a properly grounded amplifier.
10. 180º polarity reverse
The polarity reverse works with the transformer-coupled output-
B. This flips the polarity of the output to allow two amplifiers to
work ‘in-phase’.
11. Out-2: Transformer isolated output to guitar amp 2
This transformer-isolated output allows one to use two amps
without introducing noise caused by ground loops.
12. Alternate output ground disconnect (on side)
This ground switch is factory set in a LIFTED position and works
with Out-2. Connecting a ground at this output is only used
when the amplifier on Out-2 is not properly grounded with a 3-
prong AC cord.
