Radial Engineering Tonebone SWITCHBONE V2 User Manual Download Page 1

All trademarks belong to their respective owners. All references to these are for example only 
and are not associated with Radial Engineering Ltd.

Radial Switchbone V2 User Guide - Part #: R870 1030 10 / 07-2016
Appearance and speci

fi

 cations subject to change without notice.

Copyright © 2016 Radial Engineering Ltd. All rights reserved.

www.radialeng.com

THREE YEAR TRANSFERABLE LIMITED WARRANTY

RADIAL ENGINEERING LTD. (“Radial”) warrants this product to be free from defects in mate-
rial and workmanship and will remedy any such defects free of charge according to the terms 
of this warranty. Radial will repair or replace (at its option) any defective component(s) of this 
product (excluding 

fi

 nish and wear and tear on components under normal use) for a period of 

three (3) years from the original date of purchase. In the event that a particular product is no 
longer available, Radial reserves the right to replace the product with a similar product of equal 
or greater value. In the unlikely event that a defect is uncovered, please call 1-800-939-1001 
or email [email protected] to obtain a RA number (Return Authorization number) before 
the 3 year warranty period expires. The product must be returned prepaid in the original ship-
ping container (or equivalent) to Radial or to an authorized Radial repair center and you must 
assume the risk of loss or damage. A copy of the original invoice showing date of purchase 
and the dealer name must accompany any request for work to be performed under this limited 
and transferable warranty. This warranty shall not apply if the product has been damaged due 
to abuse, misuse, misapplication, accident or as a result of service or modi

fi

 cation by any other 

than an authorized Radial repair center.

THERE ARE NO EXPRESSED WARRANTIES OTHER THAN THOSE ON THE FACE 
HEREOF AND DESCRIBED ABOVE. NO WARRANTIES WHETHER EXPRESSED OR 
IMPLIED, INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MER-
CHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE SHALL EXTEND BEYOND 
THE RESPECTIVE WARRANTY PERIOD DESCRIBED ABOVE OF THREE YEARS. RA-
DIAL SHALL NOT BE RESPONSIBLE OR LIABLE FOR ANY SPECIAL, INCIDENTAL OR 
CONSEQUENTIAL DAMAGES OR LOSS ARISING FROM THE USE OF THIS PRODUCT.  
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE 
OTHER RIGHTS, WHICH MAY VARY DEPENDING ON WHERE YOU LIVE AND WHERE 
THE PRODUCT WAS PURCHASED.

Radial Engineering Ltd.
1588 Kebet Way, Port Coquitlam BC  V3C 5M5
tel:  604-942-1001 • fax:  604-942-1010 
[email protected] • www.radialeng.com

To meet the requirements of California Proposition 65, it is our responsibility to inform you of the following: 

WARNING:

 This product contains chemicals known to the State of California to cause 

cancer, birth defects or other reproductive harm.

Please take proper care when handling and consult local government regulations before discarding.

USER GUIDE

SWITCHBONE • V2

Radial Engineering Ltd.
1588 Kebet Way,  Port Coquitlam   BC   V3C 5M5      
Tel: 604-942-1001   Fax:  604-942-1010  
email: [email protected]

Summary of Contents for Tonebone SWITCHBONE V2











Reviews: