Installation
The
Radenso Pro
windshield mount allows a firm and secure installation of the radar detector at the
windshield of your vehicle. Locate an area at the windshield that enables an unobtrusive installation with clear
view to the road ahead.
1. Place the nipple of the suction cups in
the large hole of the bracket und pull the
suction cup into the small hole to secure
them. Push the rubber damper into the
hole in the middle of the bracket
Rubber
damper
2. Attach the windshield mount to the desired area of the windshield. Make sure it is in a level
position parallel to the road ahead. To adjust the angle if necessary, gently push or pull on
the bracket to bend it. DO NOT use the detector to bend the bracket.
3. Insert the windshield mount into the slot
at the front of the detector until it is
locked in position
For firm and secure adherence to the windshield keep windshield and suction cups clean
4.
Plug the small end of the power cable into the detec
t
or (located on the left side) and the large end into
your vehicle’s 12V ACC socket.
5.
To remove
Radenso Pro
from the
windshield
press the release button on top of the unit and slide the
unit off the mount.
Page 4
