Simplified EU declaration of conformity
superrollo Hausautomatisierung GmbH hereby declares that the manual
transmitter (ST110/ST115) complies with the Directive
Warranty terms and conditions
You can find information about the warranty conditions of our products
on our homepage.
Subjec
t t
o t
echnical modifica
tions
, mispr
in
ts and er
rors
.
Illustr
ations not binding
.
2.
3.
Activating or deactivating the Dot-move setting
You can use the Dot-move setting to move the roller shutter up or down in sections. You must deactivate
the Dot-move setting again to move the roller shutter up or down continuously. To activate or deactivate
the Dot-move setting, proceed as follows:
1. For the 5-channel radio transmitter ST115, use the outer buttons to select the channel on which
the motor is to be logged on. Only one LED may be lit (all LEDs = all channels)
2. Switch the motor on and wait approximately 10 seconds.
3. Press the P2 button
(1)
once on the remote control.
4. Press the UP button
(2)
on the remote control.
5. Press the P2 button
(1)
once on the remote control.
You will hear three short beeps from the motor.
Logging off a remote control
To log a remote control off from the motor, proceed as follows:
1. For the 5-channel radio transmitter ST115, use the outer buttons to select the channel on which
the motor is to be logged on. Only one LED may be lit (all LEDs = all channels)
2. Switch the motor on and wait approximately 10 seconds.
3. Press the P2 button
(1)
once on the remote control to be logged off.
4. Press the STOP button
(3)
on the remote control.
5. Press the P2 button
(1)
once on the remote control.
You will hear four short beeps from the motor.
1.
Logging the remote control onto the motor (motor on the right)
If the motor is installed on the right-hand side of the roller shutter box, establish the radio connection
between the motor and remote control in this way.
1. For the 5-channel radio transmitter ST115, use the outer buttons to select the channel on which
the motor is to be logged on. Only one LED may be lit (all LEDs = all channels)
2. Switch the motor off and wait approximately 10 seconds.
3. Switch the motor on again.
You will hear a long beep from the motor.
4. Press the P2 button
(1)
next to the battery compartment on the rear side of the remote control.
5. Press the UP button
(2)
once.
You will hear seven short beeps from the motor.
Logging the remote control onto the motor (motor on the left)
If the motor is installed on the left-hand side of the roller shutter box, establish the radio connection
between the motor and remote control in this way.
1. For the 5-channel radio transmitter ST115, use the outer buttons to select the channel on which
the motor is to be logged on. Only one LED may be lit (all LEDs = all channels)
2. Switch the motor off and wait approximately 10 seconds.
3. Switch the motor on again.
You will hear a long beep from the motor.
4. Press the P2 button
(1)
next to the battery compartment on the rear side of the remote control.
5. Press the DOWN button
(3)
once.
You will hear seven short beeps from the motor.
2.
3.
1.
2014/53/EU (Radio Equipment Directive).
The full text of the declaration of conformity is available at the following
website:
www.superrollo-online.de
superrollo Hausautomatisierung GmbH
Buschkamp 7,
46414 Rhede (Germany)
