RADEMACHER RolloTube S-line Zip DoeFern, Translation Of The Original Operating And Assembly Manual

Page: 58 / 64

58
EN
or
11. Reloading the factory settings
Self-learning mode is active again after loading the
factory settings.
Notes for carrying out the setting
◆
Use the new universal setting cable
(13)
avail-
able from a specialist retailer.
◆
The tubular motor may not be in operation.
Factory settings:
End points: no end points stored
Self-learning mode: activated
Blockage detection: activated
Obstacle detection: activated
Jog mode with a
1-pole button:
deactivated
When using the universal setting cable (20)
3.
Switch off the mains power and reset the original
connection in accordance with the connection
diagram
[ 19 to 21 ]
on pages 52 and 53 if you
have carried out the setting with the universal set-
ting cable.
1.
Button 3 - ON/SET
First, switch on the continuous phase.
ON/
SET
II I
III
2.
Button 1 -
Switch to the desired direction of travel
(I or II)
> while simultaneously (within one second) press-
ing and holding
Press and hold button 2 (set button III) until the
tubular motor confirms this by briefly running up
and down (approx. 5 seconds).
After that the factory settings are loaded.
Subsequently:
◆
Release button 2 (set button III)
◆
Button 1 (I/II) in the centre position
◆ Deactivate
button 3
(ON/SET)
+
5 sec.