5
EN
3.1 Intended use / operational conditions
Only use the tubular motors for opening and closing
standard flat roller shutters.
The use of the wrong tubular motors or compo-
nents can lead to property damage.
The motor cable must therefore be fitted with a
suitable empty tube up to the respective junction
box under observation of local electrical regula-
tions, if installed outside.
Only use the manufacturer's original parts and
accessories.
Only use tubular motors which correspond to
the local conditions in terms of their power.
Incorrectly dimensioned tubular motors can lead
to damage:
> An insufficiently dimensioned tubular motor
can be damaged due to overloading.
> An excessively dimensioned tubular motor
can, for example, cause damage to the roller
shutter or roller shutter box in self-learning
mode.
Consult a specialist retailer when selecting a
tubular motor and observe the corresponding
tractive force specifications on our website:
www.rademacher.de
Operating conditions
A 230 V / 50 Hz power supply, together with a site-
provided isolating device (fuse) must be perma-
nently available for the electrical connection at the
installation location.
The roller shutter must run up and down smoothly.
It should not jam.
Operating conditions for the self-learning
operation
The roller shutter must be fitted with stoppers or
an end-rail, see page 18.
Otherwise, the end points must be set manually
in the conventional way, see page 23 et seq.
3.2 Improper use
Using the RolloTube M-line for purposes other than
previously mentioned is impermissible.
Never use the tubular motor in systems with in-
creased safety-relevant requirements or where
there is an increased risk of accidents.
Applications of this kind require additional safety
equipment. Observe the respective statutory
regulations for the installation of such systems.
Never use the tubular motor in continuous opera-
tion. Doing so will cause serious damage.
Never use the tubular motor for shutters with
openings of ≥ 50 mm in diameter.
3.3 Required expert knowledge of the installer
The installation, electrical connection and main-
tenance must be carried out by a qualified person
with appropriate training or by a specialist roller
shutter firm in accordance with the instructions in
this manual.
i
i
i
