Registering and de-registering hand transmitters
Registering hand transmitters:
Both manual transmitters are already logged on to the large button on the garage door drive when in the factory. If you want to
log on another manual transmitter, or have already logged off a manual transmitter that is included in the scope of supply and
want to log it on again, proceed as follows.
1. Press „S“ for 2 seconds
and then let go.
2. As acknowledgement, a
green point will appear
for a short time at the
bottom right of the
display.
NOTE
After successfully registering you can operate your garage door operator with the hand transmitter. After that you can also
register further hand transmitters. You can register a maximum of 16 additional transmitters.
1. Press „S“ and
keep pressed.
2. As acknowledgement, a
green point will appear
for a short time on the
bottom right of the
display.
3. Keep „S“ pressed until the
green point at the bottom
right of the display disap-
pears.
All hand transmitters are de-registered.
You can register a new hand trans-
mitter.
De-registering hand transmitters:
For security reasons, a hand transmitter
must be de-registered in the event of loss, to
prevent the garage door from being operated
by unauthorised persons.
3. Press twice the button on the
manual transmitter you
want to use to operate the
garage door drive. A signal
tone is emitted by the drive
during the log-on process by
way of confirmation.
28
EN
Summary of Contents for RolloPort S2
Page 35: ...i 35 EN...
