Dynalyzer – High Voltage Unit
OPERATION MANUAL
29
Appendix A
Accu-Dyn+ Display System
The Accu-Dyn+ display system provides the means to display, analyze, and report values measured by the
Dynalyzer that support calibration, compliance testing, and troubleshooting. Displayed values include: kV, kV
Average, PPV, Time, anode current and mAs. In addition, waveforms of kV and anode current can be
displayed and analyzed providing a deeper understanding of the operation of the system.
Notes: kV and derived quantities are anode+cathode voltage. Waveforms and calculated values reflect a
bandwidth of 4 kHz.
Software Installation
Overview:
The Accu-Dyn+ digitizer interfaces to the computer using
Accu-Gold Excel
.
Accu-Gold Excel
is an
Excel interface for Radcal’s Accu-Gold measurement system.
Microsoft Excel
for Windows (XP
and later) is required, and the interface appears as an Excel add-in. A shortcut is installed on your
desktop that opens a folder containing Accu-Gold templates. (These templates are installed in the
‘Program Files’ folder under Radcal\AccuGoldExcel’.)
Installation:
NOTE:
Install Accu-Gold Excel
before
connecting the Accu-Dyn+ digitizer to a USB port.
Plug the flash drive into an available USB port. (Because some USB keys are not polarized, your
computer may not recognize the key; in that case rotate the key and plug it in again.)
Double-click ‘Setup.exe’. Follow the prompts to install Accu-Gold Excel.
To activate the interface for the Dynalyzer, open the Accu-Gold Excel folder on the desktop, and
then open the
Accu-Dyn
template
Connect the Accu-Dyn+ to the computer; the computer will automatically install the device. The
Accu-Dyn+ will then be ready for use. Connect the AUX and mAs cables to the rear of the
Dynalyzer
Hardware Installation
The Accu-Dyn+ digitizer
snaps onto the side of the
Dynalyzer as shown.
Hookup the two cables
from the digitizer to the
Dynalyzer. Plug in the USB
cable mini-B end into the
digitizer and the other end
to the computer or tablet.
