Chapter 3
WaveGuide system commissioning
With all the wiring in place as described in the previous chapter, the system can be con-
figured using the following steps (explained in the current chapter):
1. Connect the WaveGuide system to a computer.
2. Become an authorized user.
3. Configure the system.
4. Perform a system check.
5. Configure the distribution of data.
Step 1. Connect the WaveGuide system to a computer
Once the WaveGuide system is connected to a Local-Area-Network, communication can be
done via the available web interface (Fig. 3.1). For this purpose any web browser with
JavaScript enabled can be used.
Figure 3.1: The web interface of the WaveGuide System.
Note
A computer can be connected to the WaveGuide processing unit directly using a network
cable (a crossover cable is not required).
8
