Indicator pattern
Definition
Remark
O
ff
No power connected.
−
Solid on
Power is connected and the system is
starting.
Wait for 2 minutes, after which the in-
dicator should change its behavior.
Blink 1 time
The system is up and running, but no
network is detected.
Check the network cable connections.
Blink 2 times
The system is working normally.
This is the default mode.
Blink 3 times
The ip address was set to the default
192.168.111.71.
Check chapter 3 on how to connect to
the sensor.
Blink 3 times
The system was reverted to the factory
defaults. Also the default ip address
192.168.111.71 was set.
On release of the reset contact the sys-
tem will be restarted.
Table 11: Blinking modes
37