Connect
Action button to connect to the remote RipEX, which is specified by the IP address in the Remote box.
The Unit name in "Values from" box is changed accordingly afterwards.
Disconnect
When a Remote RipEX is sucessfully connected, the Disconnect button shows up. When the Disconnect
process is executed, the Local RipEX (IP address in the Local box) can be managed and the Unit name
in the "Values from" box changes accordingly.
7.2. Status
Fig. 7.2: Menu Status
7.2.1. Device, Radio, ETH&COM's
This part of Status page displays basic information about the RipEX (e.g. Serial No., MAC addreses,
HW versions etc.) and overview of its most important settings. Configurable items are underlined and
one click can take you to the respective Settings menu.
7.2.2. Diagnostic
The current state of Watched values is displayed in the Diagnostic part of the Status page. Watched
values are values of parameters, which are continuously monitored by RipEX itself.
On-line help for each individual item is provided by balloon tips (when cursor is placed over an item
name). When an item goes red, it means that the item is monitored for alarm and its value is in the
alarm range (see Settings/Device/Alarm management)
85
© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration
Summary of Contents for RipEX 1.6.0
Page 2: ......
