RACOM RipEX 1.12.2, User Manual

Page: 98 / 189

The MAC addresses listed in the table are blocked, i.e. all packets to/from them are discarded.
The traffic to/from other MAC addresses is allowed.
■ Whitelist
Only the MAC addresses listed in the table are allowed, i.e. only packets to/from them are
allowed. The traffic to/from other MAC addresses is blocked.
If " On " and when in the Bridge mode , a standard Layer 2 Linux firewall is activated.
○ Protocol
List box: possible values
Default = All
■ All – Ethertype is not checked, i.e. no packets are selected by the filter. addresses is allowed.
■ Manual – set 2 octets of Ethertype (in Ethernet frame) which are selected by the filter.
■ Not VLAN – only frames which are not embedded in VLAN are selected by the filter.
■ All VLAN – only VLAN frames are selected by the filter.
■ IPv4 – only IPv4 frames are selected by the filter.
■ IPv6 – only IPv6 frames are selected by the filter.
■ ARP – only ARP frames are selected by the filter.
■ LENGTH – only Ethernet frames from obsolete IEEE 802.3 Ethernet are selected by the filter.
○ VLAN
Default = None
This VLAN filter supersedes settings in Protocol. Frames with this ID of the 1st level VLAN will
be selected by the filter.
Note
When VLAN field is set, all settings in Protocol are applied to frame embedded in
VLAN (Ethertype of the 2nd level).
Alarm management
The average values of parameters listed in the table (Watched values) are continuously monitored.
When any of them exceeds the respective threshold, the selected action(s) is(are) invoked.
RipEX Radio modem & Router – © RACOM s.r.o. 98
Advanced Configuration