Device Server
Serial Port
Settings:
Configure the required RS232 parameters.
Only RS232 is supported.
Physical protocol:
Baud rate:
Specifies the baud rate of the COM port.
Data bits:
Specifies the number of data bits contained in each frame.
Parity:
Specifies the parity used with every frame that is transmitted or
received.
Stop bits:
Specifies the number of stop bits used to indicate the end of a
frame.
Software flow
control:
In XON/XOFF software flow control, either end can send a stop
(XOFF) or start (XON) character to the other end to control the
rate of incoming data.
Hardware flow
control:
While 3 wired connection is used with M!DGE hardware flow
control is not available.
Server
Configuration:
“Telnet” or “TCP raw”
Protocol on IP port:
Port:
The TCP port used by the application.
Timeout:
Endless or numbered (in seconds).
M!DGE2 GPRS/UMTS/HSPA+/LTE router – © RACOM s.r.o.
48
Web Configuration
Summary of Contents for M!DGE2
Page 2: ......
Page 188: ...188 ...
