best angle already in the factory, it is possible to make small changes in the angle of the
machine by turning the 2 feet some. The best angle is dependant from the preferable speed
of the balls and the type of balls. In the lowest position and preferable speed, the ball should
go over the net when starting. First you should set the vertical position of the shooting
wheels at the lowest position (by turning the round button most to the right). Then, the
preferable speed should be set. Then set the front feet at the height so that the balls go just
over the net. You can do this by holding the screw at the inside of the machine with a
wrench (nr 17, through the shooting hole) while turning the foot. For example high level
players like to shoot the balls at high speed and then it is preferable to shoot just close over
the net so the ball is shot inside the lines. More lower level players might want to shoot at
lower speed some higher over the net and so they should extend the front feet to shoot a
little higher over the net. A bigger vertical angle could also easily be made by using the “lob-
foot” which is in the middle under the machine, in-between the 2 front feet.
•
You can turn on the remote control before turning on the machine. When you press a button
on the RC, all the settings are sent from the RC to the ball machine. This makes it easy to
first set the right settings (speed, frequency, position, height, etc) on the RC before start
shooting (= press the “Start” button), the machine has then immediately the right
location(s)/training, the speed and the frequency for the balls.
