13
e) Installation of metal blade (for brush cutter operation)
-
Insert a metal locking tool into the hole on the side of the drive gear and on the tool drive (Fig 10).
-
Remove cover bell and the holding nut from the shaft (Fig 11).
-
Install, in the following order, on the shaft: the blade, the cover bell and then the holding nut (Fig 13).
-
Remove the metal locking tool.
NOTE
After installation, always check if the installation is correct. If blade is not well install, it will vibrate
excessively and can cause injury. When operation, if there is abnormal vibration, immediately stop
the tool and check the installation.
