Remove the vacuum tube:
1) Then turn the whole vacuum tube counterclockwise out of the machine and turn the E and F parts of
the whole vacuum tube away. (Fig.7)
2) While holding the machine, twist the the curved tube counterclockwise until it unlocks from the
machine. (Fig.5)
6. OPERATION
6.1 ADDING OIL: INITIAL USE
CAUTION! Use a high-quality SAE 30 weight oil. DO NOT use dirty oil. Failure to use clean
oil of the correct type can cause premature engine wear and failure.
Note:
This unit was shipped without oil in the crankcase.Oil must be added before starting the unit.
This unit comes with a 60 ml container of oil.
1) Set the unit on a flat, level surface.
2) Unscrew the oil fill plug (Fig. 8)
3) Pour the entire container of oil into the oil fill hole (Fig. 8)
WARNING!
DO NOT overfill. Refer to Checking the Oil Level. Never
add oil to the fuel tank.
This unit has a four-cycle engine.
DO NOT mix oil with gasoline.Wipe up any oil that may have
spilled. Make sure the O-ring is in place on the oil fill
plug Fig. 8).