Changing the Blades
Problem
Cause
Solution
Drone’s LED lights blink continuously
for more than 4 seconds after quad is
turned on. No response to controller.
No response after quad is turned on.
1. Replace batteries.
2. Reinstall batteries at correct
polarity.
Recharge quad battery.
Motor does not respond to throttle.
Motor spins but doesn’t take off.
Quad is making a loud vibration
noise.
Quad still wanders forward after trim
adjustment.
Forward trim is too high.
1. Lower forward trim.
2. Recalibrate drone.
Cannot fly after crash.
1. Motor fell out.
2. Gear loosened.
1. Reinstall motor.
2. Tighten gear.
Bent or damaged rotor blades.
1. Remote batteries have been
depleted.
2. Batteries are installed at
incorrect polarity.
1. Bent rotor blades.
2. Quad battery is depleted.
1. Replace damaged blade.
2. Recharge battery.
Replace damaged blade.
Battery has been depleted.
Unable to sync to
remote controller.
Repeat power
sequence and re-sync.
(See pg. 5)
Troubleshooting
• If a blade breaks or falls off your Quadrone during a crash, it will be up
to you to repair it. Simply push one of the extra blades onto the
exposed motor. It is important for the correct blade to be put on the
correct motor or the drone will not fly correctly. A letter is marked on
each blade to indicate which motor it should go on.
See diagram below:
A
B
A
B
A
9
Summary of Contents for QUADRONE
Page 1: ...Instruction Manual...
