06 - HD2 Connecting to the Vehicle CAN Bus
VBOX Video HD2 has the ability to capture up to 80 CAN channels from Racelogic modules and/or from a vehicle CAN
bus system.
As well as
Software Configuration (
/
)
, a hardware connection must be made to the vehicle’s CAN
bus system.
HD2 Hardware connections – Vehicle CAN
• To connect the HD2 system to an OBDII port, a
cable must be used.
for a cable drawing including PIN outs for the
RLCAB069L
.
• To connect the HD2 system to a vehicle CAN bus system using a bare wire, a
cable must be used.
for a cable drawing including PIN outs for the
RLCAB015L
.
• To connect the HD2 system to a vehicle CAN bus system by clipping on to the wires, a
cable must be
used.
Note:
If the connection needs to be made using a bare wire interface with the CAN Hi and Lo outputs of the vehicle, we
strongly recommend contacting a qualified auto-electrician to perform the fitting.
Setup diagrams are below for HD2 units with and without an OLED display.
https://en.racelogic.support//Product_Info/Video_Data_Loggers/VBOX_Video_HD2/VBOX_Video_HD2_User_Guide/06_-
_HD2_Connecting_to_the_Vehicle_CAN_Bus
45
