VBOX 3i User Guide
Page 21 of 46
28/08/2013
VCI CAN input (Vehicle CAN Interface)
The VBOX 3i can log up to 16 user defined CAN bus signals on CAN port B. Configuration is performed using the VCI Modules tab under Log Channels in
VBOXTools software setup window. CAN signal parameters can be entered manually by the user or imported directly from a CAN database (.DBC) file if available.
Racelogic supplies a free encrypted Vehicle CAN Database, giving the user the ability to log basic CAN data from a large number of current vehicles from a broad
selection of manufacturers. This CANALLCAR.REF file should be installed as part of the supplied VBOXTools installation.
CAN termination
The VBOX 3i contains an active termination between 0 Ohms and 120 Ohms, the active terminations are selectable via VBOXTools as shown above right.
NOTE: When the Usage of the CAN ports is swapped from one output socket to the other the Termination resistor setting does not follow. So you should
check that the Termination is correctly set for the output socket that you are then using.
