5
Important information
Please read this installation guide carefully before you start the
installation. The assembly normally requires a couple of minutes.
Open the bonnet, close all doors and wait approx. 5 minutes
before you start the assembly so that there is no residual
current flowing on the Common-Rail-Sensor.
If the vehicle has been moved before the installation,
please ensure that the engine is cooled down to
prevent any burn.
The function of the blind-plug is to reset the car to its original
condition (without tuning) by executing only a few steps. So
please remove the RaceChip Pro 2 with ignition off and sub-
stitute it with the blind-plug.
The factory setting of the RaceChip is a recommended
mixture of improved power, increase in torque as well as
potential fuel saving.
Due to the advanced RaceChip technology it is possible to
adjust it individually to your vehicle and your driving style
respectively. It is regulated by rotary control switches on the
circuit board inside the casing. The corresponding instruc-
tions can be found from page 8-10.
Please take care not to install the RaceChip too close to heat
sources. The cable of the RaceChip is to be led downwards.
For maximum motor safety, the maintenance intervals of
the vehicle manufacturer have to be observed, the oil types
specified by the manufacturer have to be used and
especially the oil changes prescribed by the manufacturer
have to be carried out regularly while using the RaceChip.
