CAN Bus connection
All data on the CAN bus will be recorded using Race Technology CAN RAW option. The only
required information is the CAN bus speed***.
Please ensure the minimum data available on the CAN bus contains:
•
RPM
•
Throttle pedal position
•
Boost pressure (If turbo car)
If the following data is available on the car it must also be transmitted to the DL1CLUBGTCUP:
•
Air temp
•
Water temp
•
Fuel temp
•
Wheel speeds (4)
•
Brake pressures (2)
•
Ambient air pressure
•
Gear position
•
Steering angle
•
Lambdas (2)
*** Protocol information will be requested in cases when manufacture’s CAN protocol has
not been used
Please connect to the vehicle’s main high speed CAN bus. In cases of a dedicated CAN bus for
the DL1CLUBGTCUP ensure termination resistor is installed on car loom. If the specified data is
available on the car it must be transmitted to the DL1CLUBGTCUP.
The DL1CLUBGTCUP should be mounted in the vehicle on a flat horizontal surface – a spirit
level may be added to the system to assist when fitting. The bubble must be within the inner
circle when the car is parked with all of its wheels on a levelled surface (not on the air jack).
The unit must be mounted with the connectors pointing towards the front of the vehicle –
and the LED lights and SD card pointing towards the rear.
Summary of Contents for DL1CLUBGTCUP
Page 3: ...System diagram...
Page 7: ......
