Data Logger
Quick start / system check to ensure the DL1CLUBGTCUP is operating
correctly
This test MUST be performed with the supplied SD-card inserted, power ON
and in open air conditions (outside and away from buildings – not in the pits)
with the GPS antenna correctly installed.
A, Power LED must be on solidly to indicate power to the unit
B, Logging LED must be off while vehicle is stationary, and on while car is driving faster than
50 km/h
C, GPS lock must be on no later than 2 minutes after powering up the unit in open air
conditions (not in the pits).
D, Status LED on solidly when ready to begin logging, off at all other times. The SD card must
be present, correctly formatted, and not full, to be ready for logging. Status light will be off
during logging, and when not able to log.
Contents:
Introduction
System diagram
Installation:
Sensor pre-installation requirements
Mounting instructions
CAN Bus Connection
Mounting the GPS antenna
Summary of Contents for DL1CLUBGTCUP
Page 3: ...System diagram...
Page 7: ......
